Unavailable since you have not selected any PC compatible floppy drives for Drive A: or Drive B: using “PC Floppy Disks…”, and you do not have a CD ROM drive.
Restart the SoftPC session. Equivalent to typing Control Alt Delete.
Switch between emulating an 80287 math coprocessor or not.
Unavailable since you have more than two colors available.
Switch between black on white and white on black.
Displays a dialog box to setup the amount of expanded memory (LIM).
Unavailable since either DOS is not up and running, or you do not have the HOST2.SYS device driver in your CONFIG.SYS.
Displays a dialog box to allow you to configure the PC network drives (E:,F:,…) to point to a folder on your Macintosh hard disk.
Displays a dialog to allow you to change your PC hard disk drives, C: and D:, amongst the available SoftPC hard disk documents, or to create a new one.
Displays a dialog box to allow you to change the PC floppy drives, A: and B:, amongst the available Macintosh floppy drives.
Displays a dialog box to select whether the PC parallel port LPT1 should interpret the data as Postscript or as Epson LQ2500 codes before displaying it on the printer selected in the Chooser.
Displays a dialog box to allow you to change where the two PC serial ports, COM1 and COM2, receive input from and send output to.
Switch to “PC Mouse” mode where the mouse controls the PC pointer.
Note: Command-M reverts to the usual Macintosh mouse behaviour.
Setup menu
Use this menu to change the configuration of the emulated PC.
